View TOSHIBA2-108H1A_951528.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

MIG300J2CSB1W
TOSHIBA Intelligent Power Module Silicon N Channel IGBT
MIG300J2CSB1W (600V/300A 2in1)
High Power Switching Applications Motor Control Applications
* * * * * * Integrates inverter power circuits and control circuits (IGBT drive unit, units for protection against short-circuit current, overcurrent, undervoltage and overtemperature) into a single package. The electrodes are isolated from the case. Low thermal resistance VCE (sat) = 1.9 V (typ.) UL recognized: File No.E87989 Weight: 278 g (typ.)
Equivalent Circuit
1 2 3 4 5 6 7 8
FO GND IN VD
FO GND IN VD
GND VS
OUT
GND VS
OUT
E2 C2/E1 1. 5. FO (L) FO (H) 2. 6. GND (L) GND (H) 3. 7. IN (L) IN (H)
C1
4. 8.
VD (L) VD (H)
1
2001-11-13
MIG300J2CSB1W
Package Dimensions: TOSHIBA 2-108H1A
Unit: mm
1. 5.
FO (L) FO (H)
2. 6.
GND (L) GND (H)
3. 7.
IN (L) IN (H)
4. 8.
VD (L) VD (H)
2
2001-11-13
MIG300J2CSB1W
Signal Terminal Layout
Unit: mm
1. 5.
FO (L) FO (H)
2. 6.
GND (L) GND (H)
3. 7.
IN (L) IN (H)
4. 8.
VD (L) VD (H)
3
2001-11-13
MIG300J2CSB1W
Maximum Ratings (Tj = 25C)
Stage Supply voltage Collector-emitter voltage Inverter Collector current Forward current Collector power dissipation Junction temperature Control supply voltage Input voltage Control Fault output voltage Fault output current Operating temperature Storage temperature Module Isolation voltage Screw torque AC 1 min M5 FO-GND terminal FO sink current Tc = 25C, DC Tc = 25C, DC Tc = 25C 3/4 VD-GND terminal IN-GND terminal Characteristics Condition P-N power terminal 3/4 Symbol VCC VCES IC IF PC Tj VD VIN VFO IFO Rating 450 600 300 300 1600 150 20 20 20 10 -20~+100 -40~+125 2500 3 Unit V V A A W C V V V mA C C V Nm
3/4 3/4
Tc Tstg VISO 3/4
Electrical Characteristics
1. Inverter stage
Characteristics Collector cut-off current Symbol ICEX Test Condition VCE = 600 V VD = 15 V IC = 300 A VIN = 15 V (R) 0 V Tj = 25C Tj = 125C Tj = 25C Tj = 125C Min 3/4 3/4 1.6 3/4 3/4 3/4 VCC = 300 V, IC = 300 A VD = 15 V, VIN = 15 V 0 V Tj = 25C, Inductive load (Note 1) 3/4 3/4 3/4 3/4 Typ. 3/4 3/4 1.9 2.1 2.1 2.0 0.4 0.2 1.5 0.25 Max 1 10 2.3 3/4 2.5 3.0 3/4 3/4 2.5 3/4 ms V V Unit mA
Collector-emitter saturation voltage Forward voltage
VCE (sat) VF ton tc (on)
IF = 300 A, Tj = 25C
Switching time
trr toff tc (off)
Note 1: Switching time test circuit & timing chart
4
2001-11-13
MIG300J2CSB1W
2. Control stage (Tj = 25C)
Characteristics Control circuit current Input on signal voltage Input off signal voltage Protection Fault output current Normal Overcurrent protection trip Inverter level Short-circuit protection trip level Overcurrent cut-off time Overtemperature protection Control supply under voltage protection Fault output pulse width Trip level Reset level Trip level Reset level Inverter High side Low side Symbol ID (H) ID (L) VIN (on) VIN (off) IFO (on) IFO (off) OC SC toff (OC) OT Case temperature OTr UV UVr tFO VD = 15 V 3/4 VD = 15 V Test Condition Min 3/4 3/4 1.4 2.2 3/4 3/4 480 480 3/4 110 3/4 11.5 12.0 1 Typ. 13 13 1.6 2.5 10 3/4 3/4 3/4 5 118 98 12.0 12.5 2 Max 17 17 1.8 V 2.8 12 mA 0.1 3/4 3/4 3/4 125 3/4 12.5 V 13.0 3 ms C A A ms Unit mA
VD = 15 V
VD = 15 V VD = 15 V, Tj < 125C = VD = 15 V, Tj < 125C = VD = 15 V
3. Thermal resistance (Tc = 25C)
Characteristics Junction to case thermal resistance Case to fin thermal resistance Symbol Rth (j-c) Rth (c-f) IGBT FRD Compound is applied Test Condition Min 3/4 3/4 3/4 Typ. 3/4 3/4 0.017 Max 0.078 0.130 3/4 C/W Unit C/W
5
2001-11-13
MIG300J2CSB1W
Switching Time Test Circuit
Intelligent power module TLP559 VD 0.1 mF 15 kW OUT IN 15 V 47 mF GND VS C1
GND C2/E1 VCC
VD IF = 16 mA PG 15 V 47 mF GND 0.1 mF 15 kW OUT IN VS E2
GND
Timing Chart
Input pulse 15 V VIN Waveform 0
2.5 V
1.6 V
90% Irr IC Waveform Irr 90% trr 20% Irr
VCE Waveform
10% toff
10% tc (off)
10% ton
10% tc (on)
6
2001-11-13
MIG300J2CSB1W
4. Recommended conditions for application
Characteristics Supply voltage Control supply voltage Carrier frequency Dead time Symbol VCC VD fc tdead Test Condition P-N power terminal VD-GND signal terminal PWM control Switching time test circuit (see page.6) (Note 2) Min 3/4 13.5 3/4 5 Typ. 300 15 3/4 3/4 Max 400 16.5 20 3/4 Unit V V kHz ms
Note 2: The table lists Dead time requirements for the module input, excluding photocoupler delays. When specifying dead time requirements for the photocoupler input, please add photocoupler delays to the dead time given above.
Dead Time Timing Chart
15 V VIN Waveform 0 15 V VIN Waveform 0 tdead tdead
7
2001-11-13
MIG300J2CSB1W
IC - VCE
600 600
IC - VCE
VD = 17 V VD = 13 V 400 VD = 15 V 300
500
500
(A)
IC
VD = 15 V 300
Collector current
200
Collector current
Common emitter Tj = 25C
IC
400
(A)
200 100
VD = 17 V
VD = 13 V
100
Common emitter Tj = 125C 4 0 0 1 2 3 4
0 0
1
2
3
Collector-emitter voltage
VCE
(V)
Collector-emitter voltage
VCE
(V)
Switching time - IC
10 10
Switching time - IC
(ms)
1 tc (on) tc (off) 0.1 Tj = 25C VCC = 300 V VD = 15 V L-LOAD 0 100 200 300 400
(ms)
ton toff
ton toff 1 tc (on) tc (off)
Switching time
Switching time
0.1 Tj = 125C VCC = 300 V VD = 15 V L-LOAD 100 200 300 400
0.01
0.01 0
Collector current
IC
(A)
Collector current
IC
(A)
IF - VF
600 1000
trr, Irr - IF
Peak reverse recovery current Irr (A) Reverse recovery time trr ( 10 ns)
500
(A)
Irr 100
Forward current IF
400
300
200 Common cathode : Tj = 25C : Tj = 125C 0 0 1 2 3 4
10
trr
100
Common cathode : Tj = 25C 1 0 : Tj = 125C 100 200 300 400
Forward voltage
VF (V)
Forward current
IF (A)
8
2001-11-13
MIG300J2CSB1W
OC - Tc
1000 80
ID - fc
(A)
800
(mA) Control circuit current ID
OC
Over current protection trip level
60
600
40
400
20
200 VD = 15 V 0 0 25 50 75 100 125 150
0 0 5 10 15
VD = 15 V Tj = 25C 20 25
Case temperature Tc
(C)
Carrier frequency fc (kHz)
Reverse bias SOA
OC 480
Rth (t) - tw
Transient thermal resistance Rth (t) (C/W)
1 0.3 Diode stage 0.1 0.03 0.01
560
(A) IC
400
Collector current
320 240 160 80
Transistor stage
0.003 0.001 Tc = 25C 0.0003 0.001 0.01
0 0
Tj < 125C = VD = 15 V 100 200 300 400 500 600 700
0.1
1
10
Collector-emitter voltage
VCE
(V)
Pulse width
tw (s)
Turn on loss - IC
100 100
Turn off loss - IC
Eon (mJ)
(mJ) Eoff Turn off loss
10
10
Turn on loss
1
1
0.1
0.01 0
VCC = 300 V VD = 15 V L-LOAD : Tj = 25C : Tj = 125C 100 200 300 400
0.1
VCC = 300 V VD = 15 V L-LOAD : Tj = 25C : Tj = 125C 100 200 300 400
0.01 0
Collector current
IC
(A)
Collector current
IC
(A)
9
2001-11-13
MIG300J2CSB1W
RESTRICTIONS ON PRODUCT USE
000707EAA
* TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc.. * The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's own risk. * The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. * The information contained herein is subject to change without notice.
10
2001-11-13

▲Up To Search▲

Price & Availability of TOSHIBA2-108H1A

	To Download TOSHIBA2-108H1A Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .